Oddities with removing blocks

When I have a 6-sided shape and symmetry when I remove blocks it doesn't remove the correct corresponding blocks. It instead picks random other blocks to remove.

Steps to reproduce:

1. Build a hexagon
2. Set the symmetry to the middle of the 6 triangles (attachment 1)
3. Place a TC
4. Place a Triangle extending from any point of the hexagon (attachment 2)
5. Observe that symmetry placed the other 5 triangles for you
6. Remove a triangle with the hammer and right-click
7. Observe the final result

Observed result: 5 other triangles are removed but not all correspond with the symmetric position of the removed block (attachment 3 & 4)

Expected Result: The 5 removed triangles would be the ones that were placed during step 5

okay ill need to adjust the size of the collider.. its looking for the same shape near the symmetry pos.. in this case the triangles are too close to tell apart.. if those were squares it would be able to differ.. I will look at making this a little tighter tolerance on the next update

Changed Status from Pending to Work in Progress

Changed Fixed In to Next Version

Thank you so much for your quick reply. You are correct squares work correctly in testing.

Changed Status from Work in Progress to Closed

Changed Fixed In from 1.1.0 to 1.1.4